Digital.Complex: Hi-Capa 5.1 "Clarent" - Digital.Complex

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Hi-Capa 5.1 "Clarent" 5, scratch build

#1 User is offline   aotsukisho 

  • D.C Administrator
  • PipPipPipPipPip
  • View blog
  • Group: Owner
  • Posts: 2,638
  • Joined: 18-October 05

Posted 12 October 2020 - 05:22 PM

Figured it was about time I tried building a Capa from scratch.

Posted Image
Gunsmith Bros slide, Airsoft Masterpiece outer barrel.

Posted Image
AM advance frame, 3.8 length

Posted Image
Strayer-Voigt markings below the dust cover.

Posted Image
Installing the Volante blowback unit

Posted Image
Looking at the rear of the frame, the sear assembly is held in by two pins

Posted Image
Punching out the pins to remove the assembly.

Posted Image
It has its own custom design for the main hammer sear and valve knocker.

The pipe on the left is not symmetrical, the lower section in this photo is smaller diameter to key into the frame.

Posted Image
Valve knocker lock spring might catch on the frame going in, be careful

Posted Image
Fully disassembled sear assembly

Posted Image
Hammer goes around the pipe bushing

Posted Image
AM hop unit, PDI W-hold packing, and ML Crazy Jet barrel seems to be a good combination

Posted Image
Fully assembled

Posted Image
The outer barrel is kind of loose on the hop unit due to the key needing to sit as such, I might have to replace it with a non-recoil type barrel

Posted Image
Temporary setup while I work on the lower.

I still have to order some more parts for this, namely a grip and aftermarket hammer which I forgot. A lot of the aftermarket grips don't come with a hammer spring housing and related hardware so I might have to pick up one of those too.
0

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users